5312/5324 IP Phones User Guide
To make an
Emergency Call using the Line Interface Module line:
1. Lift the handset.
2. Press the Line Interface Module key that you have programmed.
3. The set indicates IP FAIL: ANALOG CALL
4. Dial your Local Emergency Number.
To make an Emergency Call using the Line Interface Module line, when the IP
connection has failed:
1. Lift the handset.
2. Press the Line Interface Module key that you have programmed.
The set indicates IP FAIL: ANALOG CALL.
3. Dial your Local Emergency Number.
EMERGENCY CALLS WHEN EMERGENCY CALL ROUTING
PROGRAMMED
Note: This procedure is in addition to the methods described above.
To make an Emergency Call if Emergency Call Routing is programmed:
1. Lift the handset.
2. Dial your Local Emergency Number (911 or equivalent).
For more information, refer to Using the Line Interface Module.
Auto–Answer
To enable or disable Auto–Answer:
Press the programmed Auto-Answer feature key.
To enable or disable Auto-Answer on a 5324 IP Phone only:
1. Press
(APPLICATIONS).
2. Press the No softkey until "Auto Answer?" appears.
3. Do one of the following:
To enable Auto-Answer, press the TurnOn softkey.
To disable Auto-Answer, press the TurnOff softkey.
- 11 -
To Next Page
Loading...
Need help?
General
