5312/5324 IP Phones User Guide
To add a call
on Hold to an existing conversation or conference:
1. Press the AddHeld softkey.
2. Press the flashing line key.
Swap
To call another party when you are in an established two–party call:
1. Press
(TRANS/CONF).
2. Dial the number.
To alternate between the two parties:
Press the Swap/Trade feature key or the Trade softkey.
Call Forward
Call Forward lets you redirect incoming calls to an alternate number. You can select one of
the following forwarding options:
Always redirects all incoming calls regardless of the state of your telephone.
B–Int redirects internal calls when your telephone is busy.
B–Ext redirects external calls when your telephone is busy.
NA–Int redirects internal calls after several rings if you don't answer.
NA–Ext redirects external calls after several rings if you don't answer.
Note: For information about "I'm Here?", see Call Forward – Remote.
To program Call Forward:
1. Press
(APPLICATIONS).
2. Press # or the No softkey until "Call Forwarding?" appears.
3. Press * or the Yes softkey .
4. Press # or the Next softkey until the type of Call Forward that you want to set up appears
(see above).
5. On a 5324 IP Phone only, press * or the Review softkey.
6. If a number is already programmed, press * or the Change softkey .
7. Press * or the Program softkey .
8. Dial the destination number.
If you make an error while dialing, press * or the softkey to correct errors.
9. Press
(DOWN) or the Save softkey.
- 18 -
To Next Page
Loading...
Need help?
General
