5312/5324 IP Phones User Guide
Call Park
The Call Park feature allows you to place a call in a special hold state. You, or someone else,
can then retrieve the call from any extension in the system. After parking the call, the system
can automatically connect you to paging equipment so that you can announce the call to the
requested party.
To park an active call:
1. Do one of the following:
Press the Call Park feature key (must be programmed)
Press
(TRANS/CONF), and then dial *7#. The display shows PARKED@,
followed by the park destination and parking spot index (if applicable). Example:
PARKED@ 1234 @ 02.
2. Dial the directory number on which to park the call (not required if the number is
programmed to the Call Park feature key).
3. To inform a user that a parked call is waiting, do one of the following:
If automatic paging is enabled, announce the call and the park retrieve digits shown
on the display.
If automatic paging is disabled, press the programmed Page key, or dial **9, followed
by the Paging zone number (if required). Then, announce the call and park retrieve
digits shown on the display.
Note: Paging over a loudspeaker is not permitted in handsfree mode; you must use the
handset or headset.
To retrieve a parked call:
1. Do one of the following:
Dial the appropriate feature access code.
Press the Call Park - Retrieve feature key (must be programmed).
2. Dial the directory number on which the call is parked (not required if the number is
programmed to the Call Park feature key).
3. If there are multiple calls parked on the number, dial the two-digit index number to
retrieve a specific call, or # to retrieve the longest parked call.
Call Pickup
To answer a call that is ringing at another phone in your Pickup Group:
1. Lift the handset.
2. Press the Pickup feature key or the Pickup softkey.
- 24 -
To Next Page
Loading...
Need help?
General
