Mitel 5330e - Making and Answering Calls Using the Failover Mode

5330e/5340e IP Phones – User Guide
To ans
wer a waiting analog call or return to the original analog call:
1. Do one of the following:
 Press and release the hookswitch
 Press Cancel (
)
2. Press the key you have programmed as Analog Line.
To put a current call on hold to answer an incoming analog call:
 Press the highlighted Analog Line key.
To switch between the current call and the held call when one of the calls is using the
analog line, do one of the following:
 If your current call is using the analog line, press the flashing Line key of the held call.
The analog call is automatically put on hold.
 If your current call is using an IP line, press the highlighted Analog Line key. The IP line is
automatically put on hold.
To end a current call when an incoming analog call arrives:
 Press Cancel (
) and then press the highlighted Analog Line key. The current call
ends and you are connected to the caller on the analog line.
To end the current analog call when an incoming call arrives:
 Press Cancel (
). The current analog call ends and you are connected to the new
caller.
Making and Answering Calls Using the Failover Mode
To make a call using the analog line during an IP connection failure:
1. Lift the handset.
The phone displays IP FAIL: ANALOG CALL.
2. Dial the number.
To answer a call using the analog line during an IP connection failure:
 Lift the handset. The call is answered. The phone displays IP FAIL: ANALOG CALL.
- 70 -