To program Firmkeys:
1. Press Function.
2. Press [Att Function].
3. Press [Firmkeys].
The display shows the current Firmkey programming.
4. Press the blank Firmkey (not the softkey) you want to program repeatedly until the desired
options appears at that location.
For example, to program the Phone Book option to the third Firmkey from the left, continue
pressing that key until [Phonebook] appears at the [F3> location on the display.
5. Press [Save].
6. Repeat steps 4 and 5 to program the next firmkey.
7. Press [Exit].
To use the Select Options key (when more than four Firmkeys are required):
1. Press the firmkey you programmed as the Select Opt key.
2. Press the softkey that corresponds to the feature you want.
To Next Page
Loading...
