Personalizing your phone
MiVoice 5380 / MiVoice 5380 IP 97
eud-1679/1.0 – R3.0 – 08.2015
Clearing a key
You want to clear the assignment made to a configurable key.
Select the function No function to delete the function key assignment.
Function selection for configurable key
This section contains a list of all the functions you can store under a configurable key via
the menu. Contact your system administrator for more information.
<Audio setting>
Set the Audio settings:
Scroll to the required audio settings and press the Modify Foxkey. Select
the required setting and confirm with the Ok Foxkey.
➔The setting is stored.
Setting possibilities for ringing:
• Off for no ringing tone, On for instant ringing tone After10s, After20s
and ringing tone After30s and confirm with Ok Foxkey.
• You can listen to each setting using the Test Foxkey.
Answer
Setting the answering mode:
Scroll to Answer and press the Modify Foxkey.
Select the required setting and confirm with the Ok Foxkey.
➔The setting is stored.
Setting possibilities for answering:
Key to answer the call by pressing the Team key, Handset to answer by
picking up the handset, and Hands-free to answer automatically with
hands-free.
Notes:
• The Handset and Hands-free settings only work when the ringing sig-
nal is activated.
• If you select answer using Handset or Hands-free, you must also spec-
ify the Priority, with 1 being the highest priority, and 8 the lowest:
<long>
No function
To clear the Foxkey:
Press the Foxkey with a long keystroke.
➔The display shows the key type.
Scroll to No function and confirm with the Ok Foxkey.
➔The key configuration is cleared.
<long>
No function
To clear a configurable key:
Press the configurable key and hold it down for a moment.
➔The display shows the key type.
Scroll to No function and confirm with the Ok Foxkey.
➔The key configuration is cleared.
To Next Page