Mitsubishi Electric CC-Link IE - 8.1 Settings for the Master Station in MELSEC iQ-R;MELSEC iQ-F

8 PARAMETER SETTINGS
8.1 Settings for the Master Station in MELSEC iQ-R/MELSEC iQ-F
35
8
Network Configuration Settings
Set the network configuration.
Window
Displayed items
Item Description Setting range Default
[Detect Now] button Connected devices are automatically detected. ( Page 36
Automatic detection of connected device)

[Link Scan Setting] button Configure link scan settings. ( Page 39 Link Scan Setting) 
Connected Count The total number of connected slave stations is displayed. 
No. The station number of the slave station is displayed. 
Model Name Module model name is displayed.
When there is no module information, "Module With No Profile
Found" is displayed.

STA# The start station number of the slave station is displayed. 
Station Type The station type (master station/slave station) is displayed. 
RX/RY Setting Points Set the assignment of the number of points for RX/RY in
increments of 64 points.
• 64 (1 Occupied Station)
• 128 (2 Occupied Station)
• 192 (3 Occupied Station)
• 256 (4 Occupied Station)
64 (1 Occupied Station)
Start The start number of RX/RY is displayed. 
End The end number of RX/RY is displayed. 
RWw/RWr
Setting
Points The number of points for the number of stations in increments
of 32 points is displayed.

Start The start number of RWw/RWr is displayed. 
End The end number of RWw/RWr is displayed. 
Group No. Set group numbers of slave stations. 1 to 4
*1
1
RSVD STA Set whether to set the slave station as a reserved station. • No Setting
• Reserved Station
No Setting
IP Address Specify the IP address of the slave station. 0.0.0.1 to 223.255.255.254 • First to third octet: first to
third octet of the IP
address of the master
station
• Fourth octet: automatically
numbered from the number
not in use from 1 to 254 in
ascending order
Subnet Mask Specify the subnet mask of the slave station. 0.0.0.1 to 255.255.255.255 Subnet mask of the master
station
MAC Address The MAC address of the slave station is displayed. 
Comment The information entered in "Comment1" on the "Properties"
window displayed by right-clicking the module in the list of
stations or the network map is displayed.
Up to 32 one-byte
characters/16 two-byte
characters
(Empty)
Drag and drop the text.
List of stations
Network map