Mitsubishi Electric CC-Link IE - 8 PARAMETER SETTINGS

34
8 PARAMETER SETTINGS
8.1 Settings for the Master Station in MELSEC iQ-R/MELSEC iQ-F
8 PARAMETER SETTINGS
This chapter describes the parameter settings for the master station.
When the C Controller module is used, refer to the following.
MELSEC iQ-R C Controller Module User's Manual (Application)
8.1 Settings for the Master Station in MELSEC iQ-R/
MELSEC iQ-F
Settings for the master station in MELSEC iQ-R/MELSEC iQ-F are set in GX Works3.
CC-Link IEF Basic Setting
This section describes how to configure the basic settings such as whether to use CC-Link IE Field Network Basic.
• MELSEC iQ-R
[Navigation window]  [Parameter]  [CPU module model name]  [Module Parameter]  [Basic Settings]
• MELSEC iQ-F
[Navigation window]  [Parameter]  [CPU module model name]  [Module Parameter]  [Ethernet Port]  [Basic
Settings]
Window
Displayed items
Item Description Setting range Default
To Use or Not to Use CC-Link IEF
Basic Setting
Set whether to use CC-Link IE Field Network Basic. • Enable
• Disable
Disable
Network Configuration Settings Set the information of the slave station to the master station.
Moreover, configure link scan settings (timeout time and
number of retries for slave station disconnection detection).
( Page 35 Network Configuration Settings)

Refresh Settings Configure the settings to automatically link refresh RX/RY/
RWr/RWw data to the devices. ( Page 40 Refresh
Settings)
