40
8 PARAMETER SETTINGS
8.1 Settings for the Master Station in MELSEC iQ-R/MELSEC iQ-F
Refresh Settings
Set refresh parameters.
*1 These devices cannot be set for MELSEC iQ-F series modules.
Item Description Setting range Default
Link Side The number of points for the link devices (RX/RY, RWr/RWw) for
the number of occupied stations and start/end device number set
in the network configuration settings are displayed.
CPU Side Target The target destination to be link refreshed is displayed. Specify Device (Empty)
Device Name Set the device of the link refresh target. X, Y, M, L, B, D, W, R, ZR
*1
, RD
*1
(Empty)
Points The number of device points for the link refresh target is displayed.
(The same value as the number of points on the link side is
displayed.)
Start Set the start device number within the link refresh range. Follow the device settings of the
CPU parameters. ( Each
user's manual)
(Empty)
End The end device number within the link refresh range is displayed.
To Next Page
Loading...
