Mitsubishi Electric MELFA RV-2SD - Page 74

3-65 Pneumatic hand interface
3 Controller
■ Installation method
This is mounted in the controller.
Attach the pneumatic hand interface (2A-RZ365/2A-RZ375) to the CNHNDOUT/CNHND connector of the hand
interface relay card (2D-TZ315) securely. Refer to separate "Instruction Manual/ Controller setup, basic
operation, and maintenance" for details on the installing method.
Fig.3-20 ： Installation of the pneumatic hand interface(CR1DA-771/CR1DA-771-S15)
矢視A
CNHNDOUT
CNHND
エアハンドインタフェース
CNHND
CNHNDOUT
エアハンドインタフェース
（2A
-
RZ365/2A-RZ
375）
ハンドインタフェース中継カード
（2D
-
TZ315）
M4ネジ（2箇所）
A
Pneumatic hand interface
(2A-RZ365/RZ375)
Pneumatic hand interface
Hand interface relay card
View A
M4x2
* The figure is CR1DA-771.
(CR1DA-771-S15 is the same.)