Mitsubishi Electric Melsec A Series - Page 127

3 - 15
REPLACEMENT OF MELSECNET (II) AND /B (REMOTE I/O NETWORK)
3
(b) Setting ranges of MELSECNET/H link parameters
1) Setting ranges of network 1 link parameters
2) Setting ranges of network 2 link parameters
The REMFR, REMTO instructions do not use B, W, and the setting of B, W is not required.
Only X,Y are set.
L2 L3
X 0 200 67F 77F600 700
Area for M/L
I/O area used by the host
station
L2 L3
Y 0 230 680 700 77F
Area for M/L
I/O area used by the host
station
ML2 L3
B 0 100 17F 200 27F
Area for M/L
ML2 L3
W 0 100 17F 200 2BF
Area for M/L
R1 R2
X 0 200 28F 4BF400
Area for M/R
I/O area used by the host
station
R1 R2
Y 0 230 30F 480 59F
Area for M/R
I/O area used by the host
station