Mitsubishi Electric Melsec A Series - Page 128

REPLACEMENT OF MELSECNET (II) AND /B (REMOTE I/O NETWORK)
3 - 16
3
A MELSECNET/H module set as normal station requires network parameter setting. For replacement of
MELSECNET (II) module mounted on the CPU module of the AnN/AnA/AnSCPU (excluding
AnUS(H)CPU), newly set network parameters.
The following shows parameters required on each station of MELSECNET/H.
: Setting required/ : Setting required (Default setting is also acceptable)
Common parameter
(Network range assignment)
Refresh parameter
1Mp1
(Refer to example in (e) 2) and 3)) (Refer to example in (e) 4))
2MR
(Refer to example in (f) 1) and 2)) (Refer to example in (f) 3))
1Ns2
(Refer to example in (g) 2))
1Ns3
(Refer to example in (g) 2))
2R2
2R3