REPLACEMENT OF MELSECNET (II) AND /B (PLC TO PLC NETWORK)
2 - 29
2
Network parameter setting is required for control and normal stations on MELSECNET/H.
The following shows parameters required on each station of MELSECNET/H.
: Setting required/ : Setting required (Default setting is also acceptable)/ -: Setting not required
Common parameter
(Network range assignment)
Station
inherent
parameter
Refresh parameter Inter-link data transfer
1Mp3
(Refer to example in (e) 2))
-
(Refer to example in (e) 3))
1Ns2 -
(Refer to example in (f) 2))
1Ns1 -
(Refer to example in (g) 2)) (Refer to example in (h) 1))
2Mp3
(Refer to example in (g) 3))
-
(Refer to example in (g) 4))
2Ns1 -
(Refer to example in (i) 2))
2Ns2 -
(Refer to example in (i) 2))
To Next Page
Loading...
