Mitsubishi Electric MELSEC-F Series - 1 Introduction; Outline; Major Features of the FX -1 PG; External Dimensions and Part Names

1 Introduction
1.1 Outline
13
FX3U-1PG User's Manual
1
Introduction
2
Specification
3
System Configuration
4
Installation
5
Wiring
6
Before Starting Positioning Operation
7
Buffer Memory
8
Manual Control
9
Positioning Control
10
Program Example
1. Introduction
1.1 Outline
FX3U-1PG Pulse Output Block (hereinafter referred to as FX3U-1PG) is a special function block that can
output a maximum 200 kHz pulse train and drive one servo motor or stepping motor through the servo
amplifier or stepping motor driver.
1.1.1 Major Features of the FX3U-1PG
•FX3U-1PG controls the positioning operation of one servo motor or stepping motor per unit.
• A pulse train of max. 200 kHz can be output. (transistor output)
• The connected FX
3U/FX3UC
*1
PLC reads/writes the positioning data from/to the FX3U-1PG.
*1. An FX
2NC-CNV-IF or FX3UC-1PS-5V is necessary to connect the FX3U-1PG to the FX3UC PLC.
1.2 External Dimensions and Part Names
[1] Status LEDs (red)
→ Refer to Section 1.4.
[6] DIN rail mounting groove
(DIN rail: DIN46277, 35 mm (1.38") width)
[2] Extension cable [7] DIN rail mounting hook
[3] Power LED (green) [8] Terminal block (M3 screw)
[4] Direct mounting hole: 2 holes of φ4.5 (0.18")
(mounting screw: M4 screw)
[9] Extension connector
[5] Name plate
Unit: mm (inches)
MASS (Weight): Approx. 0.2 kg (0.44 lbs)
Accessories: Special unit/block No. label,
Dust proof protection sheet,
Manual supplied with product
Without top cover
[2]
[3]
[4]
[1]
[5]
[8]
[8]
[9]
[6]
[7]
87 (3.43")
9 (0.36")
43 (1.7")
4 (0.16")
90 (3.55")
2-φ4.5 mounting holes
80 (3.15")
(mounting hole pitch)