2 Specification
2.1 General Specifications
16
FX3U-1PG User's Manual
2.1 General Specifications
Items other than the following are equivalent to those of the PLC main unit.
For general specifications, refer to the manual of the PLC main unit.
→ Refer to FX
3U Hardware Edition.
→ Refer to FX
3UC Hardware Edition.
2.2 Power Supply Specifications
2.3 Performance Specifications
*1. For details of other applied instructions and methods, refer to the FX3S/FX3G/FX3GC/FX3U/FX3UC
Programming Manual.
Item Specification
Dielectric withstand voltage 500 V AC for one minute
Between all terminals and ground terminal
Insulation resistance
5 MΩ or higher by 500 V DC insulation
resistance tester
Item Specification
Drive power
supply
Input signal
24 V DC ±10%
Current consumption 40 mA or less
Output signal
For pulse output: 5 to 24 V DC Current consumption 35 mA or less
For CLR signal: 5 to 24 V DC Current consumption 20 mA or less
Inner control
5 V DC Current consumption 150 mA
(Power is supplied through the extension cable from the PLC.)
Item Specification
Number of control axes One axis
Positioning program
Created by sequence programs (using FROM/TO instruction or direct specification of
the buffer memory etc. on the MOV instruction etc.
*1
)
Positioning
Method Increment, Absolute
Unit
PLS, μm, 10
-4
inch, mdeg
Unit magnification 1, 10, 100, 1000-fold
Range -2,147,483,648 to 2,147,483,647 PLS
Operation speed Hz, cm/min, inch/min, 10deg/min
Output frequency 1 Hz to 200 kHz
Acceleration/
deceleration process
Trapezoidal acceleration/deceleration:
1 to 32,767 ms
Approximate S-shaped acceleration/deceleration:
1 to 5,000 ms
Starting time
Motor system: 1 ms or less
Machine system: 2 ms or less
Number of I/O occupied points
8 points
(taken from either the input or output points of the PLC)
To Next Page
Loading...
