Mitsubishi Electric MELSEC-F Series - Page 51

6 Before Starting Positioning Operation
6.7 Target Address Change Function
45
FX3U-1PG User's Manual
1
Introduction
2
Specification
3
System Configuration
4
Installation
5
Wiring
6
Before Starting Positioning Operation
7
Buffer Memory
8
Manual Control
9
Positioning Control
10
Program Example
4. Program description example
In the program below, the target address is changed as follows.
When turning X000 to ON, changes the target address to K15,000.
Reading of status information
Changes the target address
to K15,000
X000
Target address
change command
M8000
Error
flag
READY
M20 M27
RUN monitor
FNC 12
MOV
FNC 12
DMOV
U0\G28 K4M20
END
K15000 U0\G53