1 FUNCTIONS
1.9 File Transfer Function (FTP server)
123
1
■Subcommands usable with quote command
This section describes the Ethernet-equipped module dedicated commands added to the quote command and used.
When executing this command from the FTP client, input the subcommand after the quote command.
("" means to input CR, Enter or the Return key.)
Executing the STOP command
Input the following at the command prompt.
quote stop
The following table lists the subcommands can be used.
: Executable, : Not executable
*1
*1 If executed, the process completes abnormally.
*2 This subcommand cannot be used when the connection destination is a CPU module.
*3 This subcommand is invalid when the RUN/STOP/RESET switch of the CPU module is set to STOP.
*4 Even if the subcommand is executed, the remote password remains locked with no error occurred.
*5 This subcommand can be used only when the connection destination is a programmable controller CPU. Before using this
subcommand, check the versions of the CPU module used. ( Page 406 Added and Enhanced Functions)
Command Function CPU module status Remote password
STOP RUN Unlocked Locked
Write
enable
Write
prohibit
change Shows or changes the CPU module file attributes.
cpuchg
*2
Specifies the access destination CPU module when using a
multi-CPU system configuration.
passwd-rd Sets, shows or clears the file password (read password).
passwd-wr Sets, shows, or clears the file password (write password).
password-lock Changes the remote password from the unlock state to the
lock state.
*4
password-unlock Changes the remote password from the lock state to the
unlock state.
status Displays the CPU module operation information.
run Sets the CPU module to the RUN state.
*3
stop Sets the CPU module to the STOP state.
pm-write Writes the program memory.
fastmode
*5
Enables or disables the high-speed write mode for the CPU
module, or displays its status.
To Next Page
Loading...
