Mitsubishi Electric MELSEC iQ-RJ71EIP91 - Writing Parameters

48
2 PARAMETER SETTINGS
2.6 Writing Parameters
2.6 Writing Parameters
The parameters set on the RJ71EIP91 have different write destinations.
For writing parameters to the CPU module, refer to the following.
 GX Works3 Operating Manual
This section describes writing procedure to the RJ71EIP91.
Operating procedure
1. Switch EtherNet/IP Configuration Tool to the online state.
[File] Ö [Go Online]
2. Write the set parameters to the RJ71EIP91.
[File] Ö [Download]
The parameters written to the RJ71EIP91 with EtherNet/IP Configuration Tool are reflected when the following
operations are executed.
• 'EtherNet/IP communication start request' (Y10) is turned off and on.
• The module function block execution command is turned off and on.
Parameter type Configuration tool Write destination
Module parameter GX Works3 CPU module
EtherNet/IP communication setting EtherNet/IP Configuration Tool RJ71EIP91