Mitsubishi Electric MELSEC iQ-RJ71EIP91 - Page 88

86
3 EtherNet/IP Configuration Tool
3.1 Window Structure
■[Diagnostic] tab
The connection status of the EtherNet/IP device is displayed.
This tab can be used when diagnostic mode is enabled. ( Page 114 Network diagnostics of EtherNet/IP Configuration
Tool)
To display this content, 'EtherNet/IP communication start request' (Y10) must be turned off and on and
'EtherNet/IP communication in process' (X10) must be in the ON state.
• Diagnostic information window
No. Item Description Setting range
(1) Connection list Displays the names of the connections set on the [Connections] tab.
Diagnostic information is displayed in the connection information when
"Monitor Data And External Input" is selected.
I/O data is displayed in the connection information when "IO Data" is
selected.

(2) Refresh Every Connection information content is updated at 500ms intervals when this
check box is selected.
The update count is incremented each time the information is updated.
•Selected
• Not selected
(Default: Selected)
(3) Connection information Displays the diagnostic information and I/O data. 
(4) Status Displays the connection status. 
Item Description
Status Input Status Displays the internal status code of the input connection.
Output Status Displays the internal status code of the output connection.
General
*2
Displays the CIP general status code.
*1
Extended
*2
Displays the CIP extended status code.
*1
(1)
(4)
(3)
(2)