1 FUNCTIONS
1.7 Redundant System Function
101
1
6. Set the network configuration as follows.
[Navigation window] [Parameter] [Module Information] [RJ71GF11-T2] [Basic Settings] [Network
Configuration Settings]
7. Set the refresh settings as follows.
[Navigation window] [Parameter] [Module Information] [RJ71GF11-T2] [Basic Settings] [Refresh Settings]
8. Write the set parameters to the CPU module on the master station. Then reset the CPU module or power off and on the
system.
[Online] [Write to PLC]
In this setting example, default settings are used for the parameters other than those described. For the
parameter setting, refer to the chapter explaining the parameters in this manual. ( Page 124
PARAMETER SETTINGS)
To Next Page
Loading...
