2 PARAMETER SETTINGS
2.3 Basic Settings
133
2
Refresh Settings
Set link refresh ranges between the devices of the CPU module and the link special relay (SB), link special register (SW), and
link devices of the master/local module, or between the module label of the CPU module and the link special relay (SB) and
link special register (SW) of the master/local module.
Setting procedure
The procedure for the refresh settings is shown below.
1. Set the required items.
2. Click the [Apply] button to finish the refresh settings.
Setting items
Item Description Setting range
Device Assignment
Method
Right-click in the setting window and select a link device assignment method from
the "Device Assignment Method" menu.
• Start/End: Enter the start and end numbers of link devices.
• Points/Start: Enter the points and start numbers of link devices.
• Start/End
• Points/Start
(Default: Start/End)
To Next Page
Loading...
