2 PARAMETER SETTINGS
2.4 Application Settings
147
2
Module Operation Mode
Set the mode of the master/local module.
For the RJ71EN71 and RnENCPU, when the "Port 1 Network Type" is set to "Ethernet" and "Port 2 Network Type" is set to
"CC-Link IE Field", set both of the P1 and P2 to the same mode.
For a redundant system, select the module operation mode of system A.
For details on module communication test mode, refer to the following.
Page 221 Module communication test
The following functions are disabled when "Module Operation Mode" is set to "Offline" or "Module
Communication Test". ( Page 16 FUNCTIONS)
• Cyclic transmission
• Transient transmission
• RAS (slave station disconnection, automatic return, loopback function, submaster function)
• CC-Link IE Field Network synchronous communication function
• Interrupt request to CPU module
• IP packet transfer function
• Safety communication function
Interlink Transmission Settings
Set link device ranges when cyclic data are transferred from a station in the own network to a station in another network.
Setting procedure
The procedure for the interlink transmission settings is shown below.
1. Select combination of modules in the "Transfer Source Module" and "Transfer Destination Module" boxes and enter
setting values.
Item Description Setting range
Module Operation Mode Online
• Select this mode to connect the master/local module to the network for
performing data link with other stations.
Offline
• Select this mode to disconnect the master/local module from the network for
stopping data link with other stations.
Module Communication Test
• Select this mode to check the hardware of the master/local module. Select
this mode to check the module hardware when communication is unstable.
• Online
• Offline
• Module Communication Test
(Default: Online)
To Next Page
Loading...
