Mitsubishi Electric MELSEC iQ-RJ71GF11-T2 - Page 198

196
3 PROGRAMMING
3.4 Communication Example of Safety Communication Function Used in Redundant Master Stations
14. Set the network configuration as follows.
[Navigation window]  [Parameter]  [Module Information]  [RJ71GF11-T2(MR)]  [Basic Settings]  [Network
Configuration Settings]
15. Set the refresh settings as follows.
[Navigation window]  [Parameter]  [Module Information]  [RJ71GF11-T2(MR)]  [Basic Settings]  [Refresh
Settings]
16. Set "To Use or Not to Use the Safety Communication Setting" to "Use".
[Navigation window]  [Parameter]  [Module Information]  [RJ71GF11-T2(MR)]  [Application Settings]  [Safety
Communication Setting]  [To Use or Not to Use the Safety Communication Setting]
17. Select "Local Network" from "Communication Destination" in "Safety Communication Setting" window and display the
"Select the target module for the Safety Communication Setting" window.
[Navigation window]  [Parameter]  [Module Information]  [RJ71GF11-T2(MR)]  [Application Settings]  [Safety
Communication Setting]  [Safety Communication Setting]