284
APPX
Appendix 2 I/O Signals
Other stations data link status (X3)
This signal is used to check the data link status of other stations.
• Off: All stations normal
• On: Faulty station found
'Data link error status of each station' (SB00B0) has the same signal, but when using it in a program, use either X3 or 'Data
link error status of each station' (SB00B0) only.
If an error occurs, the faulty station can be checked by CC-Link IE Field Network diagnostics or with 'Data link status of each
station' (SW00B0 to SW00B7).
Module ready (XF)
This signal is used to check the status of module operation preparation.
• Off: Not available for module operation
• On: Available for module operation
For the module ready timing chart, refer to Module failure (X0). ( Page 283 Module failure (X0))
To Next Page
Loading...
