Mitsubishi Electric MELSERVO-J4 MR-J4 A Series - Page 121

4. STARTUP
4 - 18
4.5 Display and operation sections
4.5.1 Summary
The MR-J4-A servo amplifier has the display section (5-digit, 7-segment LED) and operation section (4
pushbuttons) for servo amplifier status display, alarm display, parameter setting, etc.
The operation section and display data are described below.
MODE UP DOWN SET
MODE
UP
DOWN
SET
⴫␜ࡕ࡯࠼ߩᄌᦝ
Low/Highߩಾ឵߃
⴫␜࡮࠺࡯࠲ߩㆫ⒖
⴫␜࡮࠺࡯࠲ߩㆫ⒖
⴫␜࡮࠺࡯࠲ߩ⏕ቯ
࠺࡯࠲ߩࠢ࡝ࠕ
ዊᢙὐLED ዊᢙὐ࡮ࠕ࡜࡯ࡓߩ᦭ήߥߤࠍ⴫␜ߒ߹ߔޕ
ὐἮߢዊᢙὐࠍ⴫ߒ߹ߔޕ
ዊᢙὐ
""(ࡑࠗ࠽ࠬ)⴫␜߇ߢ߈ߥ޿႐ว㧘ὐ
Ἦߢࡑࠗ࠽ࠬࠍ⴫ߒ߹ߔޕ
ὐṌߢࠕ࡜࡯ࡓ⊒↢ࠍ⴫ߒ߹ߔޕ
ὐṌߢ࠹ࠬ࠻ㆇォࡕ࡯࠼ࠍ⴫ߒ߹ߔޕ
5ᩴ7࠮ࠣࡔࡦ࠻LED ࠺࡯࠲ࠍ⴫␜ߒ߹ߔޕ
5-digit, 7-segment
LED
Displays data.
Decimal
LED
Displays the decimal points, alarm presence/absence, etc
Lit to indicate the decimal point
Decimal
Lit to indicate a negative when
"-" (negative) cannot be displayed.
Flickers to indicate alarm occurrence.
Flickers to indicate the test operation
mode.
Display mode change
Low/High switching
Display/data scrolling
Display/data scrolling
Display/data determination
Data clear