Mitsubishi Electric MELSERVO-J4 MR-J4 A Series - 4.5 Display and operation sections

4. STARTUP
4 - 28
4.5.6 Parameter mode
POINT
To use the I/O setting parameters, change [Pr. PA19 Parameter writing inhibit].
(Refer to section 5.1.1)
(1) Parameter mode transition
After selecting the corresponding parameter mode with the "MODE" button, pushing the "UP" or
"DOWN" button changes the display as shown below.
[Pr.PB01]
[Pr.PA02]
[Pr.PA01]
౉಴ജ⸳ቯ
ࡄ࡜ࡔ࡯࠲
[Pr.PD01]
[Pr.PD02]
[Pr.PD47]
[Pr.PD48]
[Pr.PC01]
[Pr.PC02]
[Pr.PC79]
᜛ᒛ⸳ቯࡄ࡜ࡔ࡯࠲
[Pr.PC80]
[Pr.PB02]
[Pr.PB63]
[Pr.PB64]
⁁ᘒ⴫␜ࡕ࡯࠼߳
[Pr.PA31]
ၮᧄ⸳ቯࡄ࡜ࡔ࡯࠲
[Pr.PA32]
᜛ᒛ⸳ቯ2
ࡄ࡜ࡔ࡯࠲
[Pr.PE01]
[Pr.PE02]
[Pr.PE63]
[Pr.PE64]
᜛ᒛ⸳ቯ3
ࡄ࡜ࡔ࡯࠲
[Pr.PF01]
[Pr.PF02]
[Pr.PF47]
[Pr.PF48]
ࠥࠗࡦ࡮ࡈࠖ࡞࠲
ࡄ࡜ࡔ࡯࠲
MODE
UP
DOWN
ࠕ࡜࡯ࡓࡕ࡯࠼߆ࠄ
Basic setting
parameters
Gain/filter
parameters
Extension setting
p
arameters
I/O setting
parameters
Extension setting 2
parameters
Extension setting 3
parameters
To status display mode
A
larm mode