Mitsubishi Electric MELSERVO-J4 MR-J4 A Series - When You Do Not Use the Forced Stop Deceleration Function

3. SIGNALS AND WIRING
3 - 50
(2) When the forced stop deceleration function is not enabled
MBR
(㔚⏛ࡉ࡟࡯ࠠ
ࠗࡦ࠲ࡠ࠶ࠢ)
ON
OFF
ON(ή)
OFF(᦭)
ࡌ࡯ࠬ࿁〝
(ࠨ࡯ࡏࡕ࡯࠲߳ߩ
ࠛࡀ࡞ࠡଏ⛎)
ON
OFF
ࠨ࡯ࡏࠕࡦࡊ⴫␜ㇱ
0r/min
ࠨ࡯ࡏࡕ࡯࠲
࿁ォㅦᐲ
A
LM(᡿㓚)
ࠕ࡜࡯ࡓߥߒ ࠕ࡜࡯ࡓ⇟ภ
࠳ࠗ࠽ࡒ࠶ࠢࡉ࡟࡯ࠠߦࠃࠆ೙േ
࠳ࠗ࠽ࡒ࠶ࠢࡉ࡟࡯ࠠ
+ 㔚⏛ࡉ࡟࡯ࠠߦࠃࠆ೙േ
㔚⏛ࡉ࡟࡯ࠠ૞േㆃࠇᤨ㑆
ࠕ࡜࡯ࡓ⊒↢
3.8.2 When you do not use the forced stop deceleration function
POINT
To disable the function, set "0 _ _ _" in [Pr. PA04].
The operation status during an alarm is the same as section 3.8.1 (2).
Servo motor speed
Base circuit
(Energy supply to
the servo motor)
Servo amplifier display
MBR
(Electromagnetic
brake interlock)
A
LM (Malfunction)
0 r/min
ON (no alarm)
OFF (alarm)
A
larm occurrence
Braking by the dynamic brake
Dynamic brake
+ Braking by the electromagnetic brake
No alarm
Alarm No.
Operation delay time of the electromagnetic brake