11. OPTIONS AND AUXILIARY EQUIPMENT
11 - 23
Note 1.
2.
3.
4.
5.
6.
7.
8.
When not using the phase detection terminals, fit the jumpers across RX-R, SX-S and TX-T. If the jumpers remain removed,
the FR-RC will not operate.
For the servo amplifier of 7 kW, always disconnect the lead wire of built-in regenerative resistor, which is connected to the P+
and C terminals.
If disabling ALM (Malfunction) output with the parameter, configure up the power supply circuit which switches off the magnetic
contactor after detection of alarm occurrence on the controller side.
Always connect between P3 and P4 terminals. (factory-wired) Use either the power factor improving DC reactor or the power
factor improving AC reactor. When using the power factor improving DC reactor, refer to section 11.11.
For power supply specifications, refer to section 1.3.
Set [Pr. PA04] to "0 0 _ _" to enable EM1 (Forced stop 1). Configure up the circuit which shuts off main circuitpower with
external circuit at EM1 (Forced stop 1) off.
When wires used for L11 and L21 are thinner than wires used for L1, L2, and L3, use a molded case circuit breaker.
This diagram is for sink I/O interface. For source I/O interface, refer to section 3.9.3.
(3) Dimensions
AA
A
C
F
K
EE
BA
B
E
D
Rating plate
Front cover
Display
panel
window
Mounting foot (removable)
Mounting foot
movable
Cooling fan
Heat generation area outside mounting dimension
[Unit: mm]
Power regenerative
converter
AAABBAC D EEE K F
Approxim
ate mass
[kg]
FR-RC-15K 270 200 450 432 195 10 10 8 3.2 87 19
FR-RC-30K 340 270 600 582 195 10 10 8 3.2 90 31
To Next Page
Loading...
