1 Functions and configuration
1 - 19
(4) MR-J4-700A
ࣛࣥࣀࢬ
ࣇࣝࢱ
(FR-BLF)
ᅇ⏕
࢜ࣉࢩࣙࣥ
P+
C
L11
L21
P3
P4
ࢧ࣮࣮࣎ࣔࢱ
CN2
WVU
㟁☢᥋ゐჾ
L3
(
ὀ3)
㟁※
(ὀ2)
(
ὀ1)
(MC)
ຊ⋡ᨵၿ
DCࣜࢡࢺࣝ
(FR-HEL)
ࣀ࣮ࣄ࣮ࣗࢬ
㐽᩿ჾ
(MCCB)
L2
L1
CN5
ࣃ࣮ࢯࢼࣝ
ࢥࣥࣆ࣮ࣗࢱ
MR Configurator2
CN6
CN3
CN8
CN1
ࢭ࣮ࣇࢸ࣮ࣜࣞࡲࡓࡣ
MR-J3-D05ࢭ࣮ࣇࢸ
ࣟࢪࢵࢡࣘࢽࢵࢺ
ࢼࣟࢢࣔࢽࢱ
ࣃ࣮ࢯࢼࣝࢥࣥࣆ࣮ࣗࢱ࡞
(ὀ4)
୰⥅➃Ꮚྎ
CN4
ࣂࢵࢸࣜ
RST
Note 1.
2.
3.
4.
The power factor improving AC reactor can also be used. In this case, the power factor improving DC reactor cannot be used.
When not using the power factor improving DC reactor, short P3 and P4.
For power supply specifications, refer to section 1.3.
Depending on the main circuit voltage and operation pattern, bus voltage decreases, and that may cause the forced stop
deceleration to shift to the dynamic brake deceleration. When dynamic brake deceleration is not required, slow the time to turn
off the magnetic contactor.
RS-422 communication function will be available in the future.
(Note 2)
Power supply
Molded case circuit
breaker (MCCB)
(Note 3)
Magnetic
contactor
(MC)
(Note 1)
Line noise
filter
Power factor
improving
DC reactor
Regenerative
option
Battery
Servo motor
Personal
computer
nalog monitor
Personal computer (Note 4)
To safety relay or MR-J3-
D05 safety logic unit
Junction terminal block
To Next Page
Loading...
