Mitsubishi Electric Q Series - Speed Change Gear; Operation

7 - 34
7 TRANSMISSION MODULE
7.3 Speed Change Gear
Speed change gear is used to change the rotation speed to output module and travel
value during operation.
The operation of speed change gear and parameters required to use it are shown
below.
7.3.1 Operation
This section describes the operation of speed change gear.
(1) The speed that the input axis speed multiplied by a speed change ratio set in the
speed change ratio setting device is transmitted to output axis.
[Speed change ratio]
[Output axis speed] = [Input axis speed]
10000
[PLS/s]
Speed change gear
(Speed change ratio)
Output module
Output axis