Mitsubishi Electric Q Series - Programming Software Version

1 - 10
1 OVERVIEW
1.5 Programming Software Version
The programming software versions that support Motion CPU are shown below.
MELSOFT MT Works2 (MT Developer2)
Motion CPU
SV13/SV22 SV43
MR Configurator2 MR Configurator
Q173DSCPU
1.39R
(Note-1)
1.10L Not support
Q172DSCPU
1.39R
(Note-1)
1.10L Not support
Q173DCPU-S1
1.00A
(Note-2)
1.03D
(Note-3)
1.00A
C0
(Note-4)
Q172DCPU-S1
1.00A
(Note-2)
1.03D
(Note-3)
1.00A
C0
(Note-4)
Q173DCPU 1.00A 1.03D 1.00A
C0
(Note-4)
Q172DCPU 1.00A 1.03D 1.00A
C0
(Note-4)
(Note-1): Use version 1.47Z or later to use advanced synchronous control method.
(Note-2): Use version 1.12N or later to communicate via PERIPHERAL I/F.
(Note-3): Use version 1.23Z or later to communicate via PERIPHERAL I/F.
(Note-4): Use version C1 or later to use MR Configurator combination with MT Developer2.