4 - 54
4 POSITIONING DEDICATED SIGNALS
POINT
(1) Total number of points for the user devices
6632 points
(2) (Note-1) : This device occupies only the areas of the axes set in the mechanical
system program. The unused axis areas in the mechanical system
program can be used as a user side.
(3) (Note-2) : It is valid for the version (Refer to Section 1.4) that supports
"synchronous encoder current value monitor in real mode".
(4) This manual describes only details for data registers used in the virtual mode. If it
is required, refer to the "Q173D(S)CPU/Q172D(S)CPU Motion controller
(SV13/SV22) Programming Manual (REAL MODE)".
To Next Page
Loading...
