2 - 13
2 SYSTEM CONFIGURATION
Table of Motion controller related module(continued)
Part name Model name
(Note-1)
Description
Current
consumption
5VDC[A]
Remark
MR-J3BUS M
• Q173DCPU/Q172DCPU
MR-J3- B
• MR-J3-
B
MR-J3- B
• Standard code for inside panel
• 0.15m(0.49ft.), 0.3m(0.98ft.), 0.5m(1.64ft.), 1m(3,28ft.), 3m(9.84ft.)
——
MR-J3BUS M-A
• Q173DCPU/Q172DCPU
MR-J3- B
• MR-J3-
B
MR-J3- B
• Standard cable for outside panel
• 5m(16.40ft.), 10m(32.81ft.), 20m(65.62ft.)
——
SSCNET cable
MR-J3BUS
M-B
(Note-7)
• Q173DCPU/Q172DCPU
MR-J3- B
• MR-J3-
B
MR-J3- B
• Long distance cable
• 30m(98.43ft.), 40m(131.23ft.), 50m(164.04ft.)
——
(Note-1) : =Cable length (015: 0.15m(0.49ft.), 03: 0.3m(0.98ft.), 05: 0.5m(1.64ft.), 1: 1m(3.28ft.), 2: 2m(6.56ft.),
3: 3m(9.84ft.), 5: 5m(16.40ft.), 10: 10m(32.81ft.), 20: 20m(65.62ft.), 25: 25m(82.02ft.), 30:
30m(98.43ft.), 40: 40m(131.23ft.), 50:50m(164.04ft.)
(Note-2) : 5VDC internal current consumption of shared equipments with PLC might be changed.
Be sure to refer to the PLC Manuals.
(Note-3) : Be sure to use the power supply module within the range of power supply capacity.
(Note-4) : Battery Q6BAT is not attached to Battery holder unit Q170DBATC. Please purchase it separately.
(Note-5) : Be sure to use the cable for forced stop input (sold separately). The forced stop cannot be released
without using it.
Cable for forced stop input is not attached to the Motion CPU module. Please purchase the cable for
length according to system separately.
(Note-6) : These modules can be used in Q172DLX. It cannot be controlled using Q173DPX.
(Note-7) : Please contact your nearest Mitsubishi sales representative for the cable of less than 30m(98.43ft.).
To Next Page
Loading...
