201
CHAPTER 7 POWER SUPPLY MODULE
7
7.2 Specifications
7.2.1 Power supply module specifications
Item
Performance Specifications
Q61SP
Mounting position Power supply module mounting slot
Applicable base unit Q3SB
Input power supply
100 to 240VAC
(85 to 264VAC)
Input frequency 50/60Hz ±5%
Input voltage distortion
factor
Within 5% ( Page 103, Section 4.8.1)
Max. input apparent
power
40VA
Inrush current
*1
40A within 8ms
Rated output
current
5VDC 2A
24VDC ----
Overcurrent
protection
*1
5VDC 2.2A or more
24VDC ----
Overvoltage
protection
*1
5VDC 5.5 to 6.5V
24VDC ----
Efficiency 70% or more
Allowable momentary
power failure time
*1
Within 20ms (AC100VAC or more)
Dielectric withstand
voltage
2300VAC per minute (altitude 0 to 2000m)
Between the combined "line input/LG terminals" and the "FG terminal and output"
Insulation resistance
10MΩ or higher by 500VDC insulation resistance tester
Between the combined "line input/LG terminals" and the "FG terminal and output", the line input and
LG terminals, the output and FG terminals
Noise durability
• By noise simulator of 1500Vp-p noise voltage, 1µs noise width and 25 to 60Hz noise frequency
• Noise voltage IEC 61000-4-4, 2KV
Operation indication LED indication (Normal: On (green), Error: Off)
Fuse Built-in (User-unchangeable)
Contact output section
Application
ERR.
contact ( Page 188, Section 7.1)
Rated switching
voltage, current
24VDC, 0.5A
Minimum
switching load
5VDC, 1mA
Response time OFF to ON: 10ms max. ON to OFF: 12ms max.
Life
Mechanical : More than 20 million times
Electrical : More than 100 thousand times at rated switching voltage, current
Surge
suppressor
None
Fuse None
Terminal screw size M3.5 screw
Applicable wire size
0.75 to 2mm
2
Applicable solderless
terminal
RAV1.25 - 3.5, RAV2 - 3.5, thickness 0.8mm or less. Two solderless terminals can be connected to one terminal.
Applicable tightening
torque
0.66 to 0.89N•m
+10%
-15%
To Next Page
Loading...
