Mitsubishi Electric Q26UD(E)HCPU - Appendix 6.4 Process CPU Upgrade

644
Appendix 6.4 Process CPU upgrade
(1) Added functions and supported CPU module and GX Developer versions
×: Not supported, ---: Not related to the programming tool
*1 For details, refer to the following.
Qn(H)/QnPH/QnPRHCPU User's Manual (Function Explanation, Program Fundamentals)
Function
Function
version
Serial
number (first
5 digits)
Programming tool version
GX Works 2 GX Developer
Index modification for module designation of the dedicated
instruction ( Manuals of the intelligent function modules
that support the use of dedicated instructions)
C
"07032" or later
---
Selection of refresh item for the COM instruction
( MELSEC-Q/L Programming Manual (Common
Instruction))
Online change (files) of SFC programs
*1
Version 1.87R or
later
Version 8
(Version 8.22Y
or earlier)
File memory capacity change
*1
CC-Link remote network additional mode
( CC-Link System Master/Local Module User's Manual)
Program memory check function
*1
Version 8.23Z or
later
Read of the SFC active step comment ( MELSEC-
Q/L/QnA Programming Manual (SFC))
---
Error detection in the redundant power supply system
*1
Version 1.87R or
later
Version 8.23Z or
later
Use of clock data of 1/1000 second
*1
---
Storage of sampling trace files in standard RAM
*1
Version 1.87R or
later
Version 8.23Z or
later
Individual setting of refresh device on multiple CPU system
( QCPU User's Manual (Multiple CPU System))
Execution status selection of the fall instruction during online
change
*1
"07092" or later
Version 8.27D or
later
CC-Link block data assurance per station ( CC-Link
System Master/Local Module User's Manual)
"08032" or later
Version 8.32J or
later
Setting "8" for the number of modules in Network parameter
for CC-Link ( CC-Link System Master/Local Module
User's Manual)
CC-Link IE Controller Network ( CC-Link IE Controller
Network Reference Manual)
"10042" or later
Version 8.68W
or later
SRAM card (4M bytes) (
Page 237, Section 9.2.1)
"16021" or later ---