224
(2) Slim type main base unit (Q32SB, Q33SB, Q35SB)
(3) Redundant power main base unit (Q38RB)
No. Name Application
1) Module connector
Connector for installing the Q series power supply module, CPU module, I/O modules, and
intelligent function module.
To the connectors located in the spare space where these modules are not installed, attach the
supplied connector cover or the blank cover module (QG60) to prevent entry of dirt.
2) Module fixing screw hole Screw hole for fixing the module to the base unit. Screw size: M3 × 12
3) Base unit installation hole Hole for installing this base unit on a panel such as a control panel (for M4 screw)
4) DIN rail adapter mounting hole Hole for mounting DIN rail adapter
No. Name Application
1) Extension cable connector
Connector for connecting an extension cable (for signal communications with the extension
base unit)
2) Base cover
Protective cover of extension cable connector. Before an extension cable is connected, the
area surrounded by the groove under the word "OUT" must be removed with a tool such as a
flat head screwdriver.
3) Module connector
Connector for connecting a redundant power supply module, CPU module, I/O module and
intelligent function module
To the connectors unused, attach the supplied connector cover or the blank cover module
(QG60) to prevent entry of dirt.
4) Module fixing screw hole Screw hole for fixing the module to the base unit. Screw size: M3 × 12
5) Base unit installation hole Hole for installing this base unit on a panel such as a control panel (for M4 screw)
6) DIN rail adapter mounting hole Hole for mounting DIN rail adapter
OUT
I/O7I/O6I/O5I/O4I/O3
5V
FG
SG
I/O2I/O1I/O0
5V
FG
CPU
SG
1)
2)
5)
4)
3)
6)
To Next Page
Loading...
