638
(2) Added functions and supported CPU module and programming tool versions
×: Not supported, ---: Not related to the programming tool
*1 When the CPU instruction installed by GX Developer Version 8 is read by GX Developer of Version 7 or earlier, it is
processed as an "instruction code error" by GX Developer.
*2 Unsupported by the Q00JCPU.
*3 For details, refer to the following.
Qn(H)/QnPH/QnPRHCPU User's Manual (Function Explanation, Program Fundamentals)
Function
Function
version
Serial
number (first
5 digits)
Programming tool version
GX Works2 GX Developer
Function block ( Operating manual (for function block)
for the programming tool used)
A
"04121" of
earlier
Version 1.15R or
later
Version 8.00A or
later
Structured text (ST) language ( MELSEC-Q/L
Programming Manual (Structured Text))
MELSAP3 ( MELSEC-Q/L/QnA Programming Manual
(PID Control Instructions))
B
"04122" or later
PID operation function
*1
( MELSEC-Q/L/QnA
Programming Manual (PID Control Instructions))
Real number operation
*1*3
Intelligent function module event interruption
*3
Device initial value automatic setting function
*3
Remote password setting function
*3
E-mail parameter ( Manual of the module that supports
the e-mail function)
Online change using pointer
*3
Increased file register capacity (32K points to 64K points)
*2*3
---
Multiple CPU system ( QCPU User's Manual (Multiple
CPU System))
Version 8.00A or
later
Online change (multiple blocks)
*3
CC-Link Remote network additional mode ( CC-Link
System Master/Local Module User's Manual)
"06112" or later
Version 8.03D or
later
To Next Page
Loading...
