Mitsubishi Electric Q26UD(E)HCPU - Page 69

67
CHAPTER 4 INSTALLATION AND WIRING
4
4.2 Mounting a Module 4.2.2 Base unit installation
• For Q00JCPU, Q00UJCPU, Q33B, Q35B, Q35DB, Q65B, Q52B, Q55B, Q63B, Q32SB, Q33SB or Q35SB
type
Screw the DIN rail in two places using the mounting screws and square washers included with the
adaptors in 'Position A' (bottom of base unit).
*1 The following shows where to position the square washers.
*2 Screw the DIN rail to a control panel using the mounting screws and square washers included with the adaptors in
'Position A' (bottom of base unit).
*3 Screw the DIN rail with mounting screws(obtained by user) in 'Position B' (Where the base unit is not installed). In this
method the supplied mounting screws and square washers are not used.
● Use only one washer for each mounting screw. Use only the square washers supplied with the adaptors.
If two or more washers are used together for one mounting screw, the screw may interfere with the base unit.
● Make sure to align the square washer sides with the DIN rail.
● Use the DIN rail that is compatible with M5 size screws.
DIN rail
35mm
P
P=200mm or less
PP
Stopper
Stopper
A *2B *3 B *3
Mounting screws
(included with adaptors)
Square washers necessary*1
Mounting screws (obtained by user)
No square washers
DIN rail
Mounting screws
(M5 10)
Square washer
Side view A
DIN railMounting screws
square washer
Mounting side
(e.g. Control panel)
Side view A
DIN railsquare washer DIN railsquare washer