N00562001062
N00562101076
1. Before replacing the battery, remove static
electricity from your body by touching a
metal grounded object.
2. With the Mitsubishi mark facing you,
insert the cloth-covered tip of a flat blade
screwdriver into the notch in the case and
use it to open the case.
3. Remove the old battery.
4. Install a new battery with the +side (A)
up.
5. Close the case firmly.
6. Check the keyless entry system to see that
it works.
General information
Your F.A.S.T.-key operates on a radio fre-
quency subject to Federal Communications
Commission (FCC) Rules (For vehicles sold
in U.S.A.) and Industry Canada Rules (For
vehicles sold in Canada). This device com-
plies with Part 15 of FCC Rules and Industry
Canada licence-exempt RSS standard(s).
Operation is subject to the following two con-
ditions.
•This device may not cause harmful
interference.
•This device must accept any interference
received, including interference that
may cause undesired operation.
Changes or modifications not expressly
approved by the manufacturer for compli-
ance could void the user’s authority to oper-
ate the equipment.
Procedure for replacing the
remote control transmitter bat-
tery
Be sure to perform the procedure with the
Mitsubishi mark facing you. If the Mitsubi-
shi mark is not facing you when you open the
case, the transmitter may come out.
You may purchase a replacement battery at
an electric appliance store.
An authorized Mitsubishi Motors dealer can
replace the battery for you if you prefer.
When the remote control transmitter case is
opened, be careful to keep water, dust, etc.
out. Also, do not touch the internal compo-
nents.
To Next Page
Loading...
Need help?
General
