N00510601144
Use the following procedure to test the sys-
tem:
1. Lower the driver’s window.
2. Arm the system as explained in “Armed
stage”.
3. Make sure that the theft-alarm indicator
comes on and flashes for approximately
20 seconds.
4. Wait a few seconds and then unlock the
driver’s side door by using the inside door
lock knob. Open the door.
5. Make sure that the horn (the siren for
vehicles equipped with the interior alarm
sensor) sounds intermittently and the
headlights blink when a door is opened.
6. Disarm the system by unlocking all doors
and the liftgate by using the keyless entry
system or the F.A.S.T.-key operation.
N00510800383
Testing the theft-alarm system
Power window control
1- Open (down)
2- Close (up)
Never try to operate the main switch and
sub-switch in different directions at the same
time. This will freeze the window in posi-
tion.
Operating the power windows repeatedly
with the engine stopped will run down the
battery. Use the window switches only while
the engine is running.
Before operating the power windows,
make sure that nothing can be trapped
(head, hands, fingers, etc.) in the window.
Never leave the vehicle without carrying
the key.
Never leave children or unreliable adults
unattended inside the vehicle.
To Next Page
Loading...
Need help?
General
