N00954901141
1. Before replacing a fuse, always turn off
the electrical item connected to the fuse
and turn the ignition switch to the
“LOCK” or “OFF” position or put the
operation mode in OFF.
2. There is a fuse remover (A) in the engine
compartment fuse block.
3. Clamp it on the fuse you wish to remove,
and pull the fuse straight out from the fuse
block.
4. Use the fuse location diagrams and the
matching tables, to check the fuse that is
related to the problem. If the fuse is not
blown, something else must be causing
the problem. Have the system inspected
by your authorized Mitsubishi Motors
dealer or a repair facility of your choice.
5. Insert a new fuse of the same capacity
securely into the appropriate slot.
N00942901359
Before replacing the bulb, be sure the light is
off. Do not touch the glass part of the new
bulb with your bare fingers; the oil from your
skin will stay on the glass and dim or destroy
the bulb when it gets hot.
Fuse replacement
B- Fuse is OK
C- Blown fuse
Never use a fuse with a capacity greater than
the one listed or any substitute, such as wire,
foil etc. This would cause the circuit wiring
to heat up and could cause a fire.
If the replacement fuse blows again after a
short time, have the electrical system
checked by an authorized Mitsubishi Motors
dealer or a repair facility of your choice to
find and correct the cause.
Replacement of light bulbs
Bulbs are extremely hot immediately after
being turned off.
When replacing the bulb, wait for it to cool
sufficiently before touching it. You could
otherwise be burned.
BK0223400US.book 29 ページ ２０１５年２月１３日 金曜日 午後１２時１５分
To Next Page
Loading...
Need help?
General
