N00628600033
The original equipment floor mat provided
with your vehicle was specifically designed
for your vehicle.
Always properly position the floor mat and
assure it does not interfere with operation of
the pedals. Always use the retaining clip on
the driver’s floorboard to secure the floor
mat. When used, this clip will help prevent
the floor mat from moving forward and possi-
bly interfering with the operation of the ped-
als. To prevent the floor mat from moving
forward and possibly interfering with the
operation of the pedals, Mitsubishi genuine
floor mats are recommended.
N00628700050
1. Place the floor mat to fit the shape of the
floorboard.
2. Align the floor mat with the installation
holes over the retaining clips.
3. Secure the floor mat with retaining clips.
Floor mat
To install the floor mat
If a floor mat is the wrong size or is not
properly installed, it can interfere with the
operation of the pedals. Interference with
the pedals can cause unintended accelera-
tion and/or increased stopping distances
resulting in a crash and injury. Always
make sure the floor mat does not interfere
with the accelerator or brake pedal.
Always use the retaining clip on the
driver’s floorboard to secure the floor
mat.
Always install the mat with the correct
side facing down.
Never install a second mat over or under
an existing floor mat.
Do not use a floor mat designed for
another model vehicle even if it is a Mit-
subishi genuine floor mat.
Before driving, be sure to check the fol-
lowing:
• Periodically check that the floor mat is
properly secured with the retaining clips.
If you remove the floor mat while clean-
ing the inside of your vehicle or for any
other reason, always check the condition
of the floor mat after it has been rein-
stalled.
• While the vehicle is stopped with the
engine off, check that the floor mat is not
interfering with the pedals by depressing
the pedals fully.
To Next Page
Loading...
Need help?
General
