Mitsubishi 2016 OUTLANDER User Manual

Adaptive Cruise Control System (ACC) (if so equipped)
5-100 Features and controls
5
The set speed driving is deactivated automati-
cally in any of the following ways.
 When your speed slows to about 10 mph
(15 km/h) or more below the set speed
because of a hill, etc.
 When your speed slows to about 25 mph
(40 km/h) or less.
 When the active stability control (ASC)
starts operating. (if so equipped)
Refer to “Active stability control (ASC)”
on page 5-94.
Also, the set speed driving may be deacti-
vated as follow:
 When the engine speed rises and
approaches the tachometer’s red zone (the
red-coloured part of the tachometer dial).
N00518901345
If the set speed driving is deactivated by the
condition described in “To deactivate” on
page 5-99, you can resume the previously set
speed by push up the RES+ switch (C) while
driving at a speed of about 25 mph (40 km/h)
or higher.
The “SET” indicator appears on the informa-
tion display in the meter cluster. (For vehicles
equipped with the color liquid crystal display
meter)
Under either of the following conditions,
however, using the switch does not allow you
to resume the previously set speed. In these
situations, repeat the speed setting procedure:
 The CRUISE CONTROL ON/OFF
switch is pressed.
 The operation mode is put in OFF.
 Indicator go off.
N00576800048
ACC maintains a set speed with no need for
you to use the accelerator pedal. Using a sen-
sor (A), the system also measures the relative
speed and distance between your vehicle and
a vehicle in front, and maintains a set follow-
ing distance between your vehicle and the
vehicle in front by automatically decelerating
WARNING
 Although the set speed driving will be
deactivated when shifting to the “N”
(NEUTRAL) position, never move the
selector lever to the “N” (NEUTRAL)
position while driving.
You would have no engine braking and
could cause a serious accident.
CAUTION
 When the set speed driving is deactivated
automatically in any situation other than
those listed above, there may be a system
malfunction.
Press the CRUISE CONTROL ON/OFF
switch to turn off the cruise control and have
your vehicle inspected by an authorized Mit-
subishi Motors dealer or a repair facility of
your choice.
To resume the set speed
Adaptive Cruise Control
System (ACC)
(if so equipped)
BK0223400US.book 100 ページ ２０１５年２月１３日 金曜日 午後１２時１５分
Information Provided by:

Mitsubishi 2016 OUTLANDER Specifications

General

Brand	Mitsubishi
Model	2016 OUTLANDER
Category	Automobile
Language	English