Cruise control (if so equipped)
5-96 Features and controls
N00546601129
If an abnormal condition occurs in the sys-
tem, the following display/indicator will turn
on.
Warning display
N00546301070
N00518301626
Cruise control is an automatic speed control
system that keeps a set speed. It can be acti-
vated at speeds from about 25 mph
(40 km/h). Cruise control does not work at
speeds below about 25 mph (40 km/h).
The indicator may come on when you
start the engine. This means that the battery
voltage momentarily dropped when the
engine was started. It does not indicate a
malfunction, provided that the display goes
out immediately.
When a spare tire has been put on your vehi-
cle, the gripping ability of the tire will be
lower, making it more likely that the dis-
play/indicator will blink.
ASC warning display
-
ASC indicator
-
ASC OFF indicator
The system may be malfunctioning.
Park your vehicle in a safe place and stop the
engine. Restart the engine and check whether
the display/indicator goes out. If they go out,
there is no abnormal condition. If they do not
go out or if they turn on frequently, it is not
necessary to stop the vehicle immediately,
but you should have your vehicle inspected
by an authorized Mitsubishi Motors dealer or
a repair facility of your choice as soon as
possible.
Towing
If the 2WD vehicle is towed with the ignition
switch in the “ON” position or the operation
mode in ON and only the front wheels or
only the rear wheels raised off the ground,
the ASC may operate, resulting in an acci-
dent. When towing the 2WD vehicle with the
front wheels raised, keep the ignition switch
in the “OFF”, “LOCK” or “ACC” position or
the operation mode in ACC or OFF. When
towing the vehicle with the rear wheels
raised, keep the ignition switch in the “ACC”
position or the operation mode in ACC.
Refer to “Towing” on page 8-14.
Cruise control (if so equipped)
When you do not wish to drive at a set speed,
turn off the cruise control for safety.
Do not use cruise control when driving con-
ditions will not allow you to stay at the same
speed, such as in heavy traffic or on roads
that are winding, icy, snow-covered, wet,
slippery, on a steep downhill slope.
Cruise control may not be able to keep your
speed on uphills or downhills.
Your speed may decrease on a steep uphill.
You may use the accelerator pedal if you
want to stay at your set speed.
Your speed may increase to more than the set
speed on a steep downhill. You have to use
the brake to control your speed. As a result,
the set speed driving is deactivated.
BK0223400US.book 96 ページ ２０１５年２月１３日 金曜日 午後１２時１５分
To Next Page
Loading...
Need help?
General
