HomeLink® Wireless Control System (if so equipped)
5-220 Features and controls
N00554301040
HomeLink
®
Wireless Control System is a
registered trademark of Gentex Corporation.
HomeLink
®
provides a convenient way to
replace up to 3 hand-held radio-frequency
(RF) transmitters used to activate devices
such as gate operators, garage door openers,
entry door locks, security systems, even home
lighting. Additional HomeLink
®
information
can be found at www.homelink.com,
www.youtube.com/HomeLinkGentex, or by
calling the toll-free HomeLink
®
-Hotline at 1-
800-355-3515.
HomeLink
®
Wireless Con-
trol System
(if so equipped)
Do not use HomeLink
®
with any garage
door opener that lacks safety stop and
reverse features as required by U.S. Fed-
eral Regulations. A garage door opener
which cannot detect an object in the path
of a closing garage door and then auto-
matically stop and reverse, does not meet
current U.S. Federal Regulations. Using a
garage door opener without these features
increases the risk of serious injury or
death.
During programming, your garage door
or gate may open or close. Make sure that
people and objects are clear of the garage
door or gate that you are programming.
Once HomeLink
®
is programmed, retain the
original transmitter for future programming
procedures (for example, new vehicle pur-
chases). Upon sale of the vehicle, the pro-
grammed HomeLink
®
buttons should be
erased for security purposes. Refer to
“Cleaning the programmed information” on
page 5-224.
You can program a maximum of 3 devices.
To change or replace any of the 3 devices
after it has been initially programmed, you
must first erase the current settings.
See “Cleaning the programmed information”
on page 5-224 or “Reprogramming a single
HomeLink
®
button” on page 5-224.
1-
HomeLink
®
button 1
2-
HomeLink
®
button 2
3-
HomeLink
®
button 3
BK0223400US.book 220 ページ ２０１５年２月１３日 金曜日 午後１２時１５分
To Next Page
Loading...
Need help?
General
