Making a cargo area
4-12 Seat and restraint systems
Press the lock knob (A) in the direction
shown by the arrows. Then pull the head
restraint up and out of the seatback.
First check that the head restraint is facing in
the right direction as shown in the previous
illustration, and then insert it into the seat-
back. Push the head restraint down while
pressing the lock knob (A) until the restraint
locks into place.
N00405501115
To remove
To help minimize the risk of neck injury in
the event of an accident, the head
restraints must be properly installed and
positioned to proper height before vehicle
operation.
To install
Check that the lock knob (A) is extended out
as shown in the illustration. Then pull the
head restraint up to make sure that it is
locked in place and will not come out of the
seatback.
The shape and size of the head restraint dif-
fers according to the seat. Always use the
correct head restraint provided for the seat
and do not install the head restraint in the
wrong direction.
Making a cargo area
Never adjust the seats to make a cargo
area when the vehicle is in motion or on a
slope. The seats could move more than
necessary or move suddenly and causing a
serious accident and/or injury.
When returning a seat back to its seating
position after folding down, make sure
that the seat is firmly secured and seat belt
buckles are in proper position. If the seat
is not secured, it could move causing a
serious accident.
Do not allow anyone to ride in the cargo
area while the vehicle is in motion. People
who are not properly seated and
restrained can be seriously injured or
killed in an accident.
BK0223400US.book 12 ページ ２０１５年２月１３日 金曜日 午後１２時１５分
To Next Page
Loading...
Need help?
General
