Mitsubishi 2016 OUTLANDER User Manual

Automatic climate control air conditioner
7-10 Comfort controls
7
When the air conditioning turns on, the air
selection is controlled automatically. When
the air conditioning turns off, the air selection
automatically goes back to the outside posi-
tion.
If high cooling performance is desired, or if
the outside air is dusty or contaminated in
some way, use the recirculation position.
Switch to the outside position every now and
then to keep the windows from fogging up.
N00712300036
You can change the following functions to
match your preference.
 Enable automatic air selection control:
When the AUTO switch is pressed, the air
selection switch will also be automatically
controlled.
 Disable automatic air selection control:
Even when the AUTO switch is pressed,
the air selection switch will not be auto-
matically controlled.
 Changing the settings
Press the air selection switch for approxi-
mately 10 seconds or longer.
When the setting has changed, the system
will beep and the indicator light will flash.
• When the setting has changed from
enabled to disabled, the system will beep
three times and the indicator light will
flash three times.
• When the setting has changed from dis-
abled to enabled, the system will beep
two times and the indicator light will
flash three times.
On vehicles equipped with Mitsubishi
Multi-Communication System, screen
operations can also be used to change the
setting. Refer to the separate owner’s
manual for details.
N00737301353
Push the switch, and the air conditioning
compressor will turn on. The “ ” indicator
will be shown in the display (A).
CAUTION
 Using recirculated air for a long time may
cause the windows to fog up.
NOTE
 If the mode selection is set “ ” position,
you cannot turn the air conditioner off or
select the recirculation position.
This prevents the windows from fogging up.
 When the engine coolant temperature rises to
a certain level, the air selection is automati-
cally switched to the recirculation position
and the indicator light (A) comes on. At this
time, the system will not switch to the out-
side position even if the air selection switch
is pushed.
 Personalizing the air selection
(Changing the function setting)
NOTE
NOTE
 The factory setting is “Enable automatic air
selection control”.
 When the defogger switch is pressed, the air
selection will automatically change to the
outside air position, even if the system is set
to “Disable automatic air selection control”,
in order to prevent windows from fogging
up.
Air conditioning switch
BK0223400US.book 10 ページ ２０１５年２月１３日 金曜日 午後１２時１５分
Information Provided by:

Mitsubishi 2016 OUTLANDER Specifications

General

Brand	Mitsubishi
Model	2016 OUTLANDER
Category	Automobile
Language	English