Wiper and washer switch
Features and controls 5-185
N00523001722
The windshield wiper and washer can be
operated with the ignition switch or the oper-
ation mode is in ON or ACC.
If the blades are frozen to the windshield, do
not operate the wipers until the ice has melted
and the blades are freed, otherwise the wiper
motor may be damaged.
With the lever in the “INT” (speed sensitive
intermittent operation) position, the intermit-
tent intervals can be adjusted by turning the
knob (A).
If the headlights are switched to high beam,
the front fog lights will go out; they will illu-
minate again when the headlights are
switched back to low beam.
If the light switch is rotated to the “OFF” or
“ ” position while the front fog lights are
illuminated, they will automatically turn off.
They can be turned back on again by rotating
the combination headlights and dimmer
switch back to “ ” position, and turning
the knob in the direction of the “ON” posi-
tion.
Do not use fog lights except in conditions of
fog, otherwise excessive light glare may
temporarily blind oncoming vehicle drivers.
Wiper and washer switch
If the washer is used in cold weather, the
washer fluid sprayed against the glass may
freeze, which may hinder visibility. Warm
the glass with the defroster before using the
washer.
Windshield wipers
To ensure a clear rearward view, the rear
window wiper will automatically perform
several continuous operations if the selector
lever is put in the “R” position while the
windshield wipers are operating.
Refer to “Rear window wiper and washer”
on page 5-189.
Except for vehicle with rain sensor
MIST- Misting function
The wipers will operate once.
OFF- Off
INT- Intermittent (Speed sensitive)
LO- Slow
HI- Fast
To adjust intermittent intervals
BK0223400US.book 185 ページ ２０１５年２月１３日 金曜日 午後１２時１５分
To Next Page
Loading...
Need help?
General
