The misting function can be used when the
ignition switch or the operation mode is in
ON or ACC.
The wipers will operate once if the wiper
lever is raised to the “MIST” position and
released. This operation is useful when it is
drizzling, etc. The wipers will continue to
operate while the lever is held in the “MIST”
position.
The windshield wipers can be operated with
the ignition switch or the operation mode is in
ON or ACC.
If the blades are frozen to the windshield or
rear window, do not operate the wipers until
the ice has melted and the blades are freed,
otherwise the wiper motor may be damaged.
Can only be used when the ignition switch or
the operation mode is in ON.
If the lever is put in the “AUTO” position, the
rain sensor (A) will detect the extent of rain
(or snow, other moisture, dust, etc.) and the
wipers will operate automatically.
Keep the lever in the “OFF” position if the
windshield is dirty and the weather is dry.
1- Fast
2- Slow
The speed-sensitive-operation function of
the windshield wipers can be deactivated.
For further information, please contact your
authorized MITSUBISHI MOTORS dealer
or a repair facility of your choice. On vehi-
cles equipped with Mitsubishi Multi-Com-
munication System, screen operations can be
used to make the adjustment.
Refer to separate owner’s manual for details.
Misting function
Vehicle with rain sensor
MIST- Misting function
The wipers will operate once.
OFF- Off
INT- Auto-wiper control
Rain sensor
The wipers will automatically oper-
ate depending on the degree of wet-
ness on the windshield.
LO- Slow
HI- Fast
Rain sensor (if so equipped)
BK0223400US.book 186 ページ ２０１５年２月１３日 金曜日 午後１２時１５分
To Next Page
Loading...
Need help?
General
