Press the switch (1), the sunroof automati-
cally opens.
To stop the moving sunroof, press the switch.
Press the switch (3), the sunroof automati-
cally closes.
To stop the moving sunroof, press the switch.
When the switch (2) is pressed, the rear of the
sunroof raises for ventilation.
Press the switch (3).
The sunroof can be operated when the igni-
tion switch or the operation mode is in ON.
The sunroof can be opened or closed for a 30-
second period after the engine is stopped.
However, when the driver’s door or the front
passenger door is opened, the sunroof cannot
be operated. Turn on the ignition switch again
to operate.
If a hand or head is trapped in the closing
sunroof opening, the safety mechanism will
cause the sunroof to re-open automatically.
The opened sunroof will become operational
again after a few seconds.
If the safety mechanism is activated 5 or
more times consecutively, normal closing of
the sunroof will be aborted.
As an emergency measure, the sunroof can be
closed bit by bit until the sunroof is com-
pletely closed by repeatedly pressing the
switch (2).
After that, the sunroof can be set the initial-
ized state in the following procedure.
1. Move the sunroof in slide open position.
2. Press the tilt up switch (2) continually in
10 seconds.
3. The sunroof will be moved to tilt up posi-
tion automatically bit by bit.
4. The initialize is completed when the sun-
roof is stopped at tilt up position.
If the sunroof does not return to normal,
consult an authorized Mitsubishi Motors
dealer.
To open
The safety mechanism is deactivated while
the switch (2) is pressed. Therefore be espe-
cially careful that fingers are not trapped in
the sunroof opening.
Do not deliberately trap your hands or head
in order to activate the safety mechanism.
Personal injury and malfunction of the sun-
roof could result.
BK0223400US.book 52 ページ 2015年2月13日 金曜日 午後12時15分